facebook pixel Repair an Entry Door Threshold | HomeTips
Select Page

Repair an Entry Door Threshold

Expert advice on how to repair or replace a damaged exterior door threshold, including how to replace a threshold gasket

A threshold at the base of an exterior door is important for properly sealing your home against water damage and air infiltration. Because a threshold receives heavy foot traffic and a lot of general wear and tear, repairs or complete replacement are sometimes necessary.

Replacement threshold made of bronze-finished aluminum easily replaces an old threshold. Photo: M-D Building Products

Replacement threshold made of bronze-finished aluminum easily replaces an old threshold. Photo: M-D Building Products

How to Replace a Threshold

Replacing a door threshold is not just for the sake of appearances, it can also be a real energy saver. The threshold at the base of an exterior door takes a beating with constant foot traffic and weathering. As it ages or—worse—rots, it looks bad and ceases to do an effective job of sealing out the weather. That?s when it’s time to replace it.

The following instructions will guide your through replacing a wooden threshold:

1Remove the damaged threshold. If necessary, cut it in two and pry out the pieces. Be careful not to cut or pry against your finish flooring.

2Mark and cut the replacement threshold to fit. You may be able to use the two sections of the old threshold to help measure and mark the new threshold—if you do, be sure to allow for the width of the saw cut you made during removal.

3Cut the replacement threshold. (If you’re installing a metal one, use tin snips and a hacksaw or a saber saw with a metal-cutting blade to make the cuts.)

4Brush or sweep the area where the threshold will go.


5Set the new threshold into position and test it for fit. Temporarily remove it and apply silicone caulk to seal it to the floor. Replace it and attach it to the floor with screws, countersinking their heads (for a metal threshold, follow the manufacturer’s directions; if it includes a rubber gasket, cut this to length and install it as well).

How to Replace a Threshold Gasket

If you have an exterior door with a threshold that’s capped by a rubber gasket and the gasket is broken or badly worn, here is how to replace it:

Remove the door. Use an old chisel or screwdriver to pry out the splines that hold the gasket in place (if there are splines), and then pry up the gasket and pull it out of its groove.

Take the old gasket to a home improvement center or hardware store and buy an exact replacement. Most new gaskets just press into place (you can force the new gasket, if necessary, by pushing it against a short wooden block).

Find Local Pre-Screened Door Repair Pros

About Don Vandervort
Author Image
Don Vandervort developed his expertise more than 30 years ago as Building Editor for both Sunset Books and Home Magazine. He has written more than 30 home improvement books and countless magazine articles. He appeared regularly on HGTV’s “The Fix,” and served as MSN’s home expert. Don founded HomeTips in 1996.

Related Posts:

Join the Conversation

Submit a Comment

Your email address will not be published. Required fields are marked *