How to Install an Electronic Thermostat | HomeTips
Select Page

How to Install an Electronic Thermostat

Programmable electronic thermostats help you save money and energy by allowing you to pre-program temperature settings for maximum efficiency during the day and night.

An electronic thermostat offers energy-efficient control.

These can easily replace single-setting thermostat models, as they also work with standard central air and heating systems.

Here is how to replace your older thermostat with a programmable model:

1Remove the old thermostat. After making sure the power to the furnace is disconnected, remove the old thermostat’s cover, unscrewing any screws that fasten it in place.

Disassemble old thermostat and label the wires according to their terminals.

2Carefully disconnect each wire from the thermostat, and bend them slightly so they do not sink behind the base. Place a small label at the end of each wire, writing down the letter that is next to each wire’s terminal.

3Unscrew and remove the base of the thermostat from the wall, and hold onto the wires as you do so. Secure the wires around a paper clip, pen, or other similar object that will weigh them down enough so that they do not slip backwards into the hole in the wall.

4Strip about half an inch of casing from the end of each wire if the wires are not already stripped. Rub the exposed copper with something made for cleaning metal, such as an emery cloth or a steel-wool sponge.

Thread the wires through the new thermostat’s base and attach it to the wall.

5Detach the base from the cover of  the new thermostat. Unfurl the pen or other object you have used as a weight from the wires, and loop them through the new base so that they appear under the terminal block. Reattach the weighted object to hold the wires in place.

6Mount the new thermostat’s base. Stuff a few paper towels into the hole in the wall behind the thermostat. (This will protect your device from drafts.) Place the base against the wall, and put a level on top to ensure it is evenly in place. Using a pencil, mark the areas where you will set your screws. Proceed to screw the base to the wall, using regular screws for wood and anchor screws for drywall.

7Connect the wires, following the instructions in your new thermostat’s manual and keeping wires separate from one another. If called for, install batteries into the device to provide a backup power supply. Attach the cover.

8Turn the power back on, and program your thermostat according to the manufacturer’s instructions.

Featured Resource: Find Pre-Screened Local Thermostat Installation Help

About Don Vandervort
Author Image
Don Vandervort developed his expertise more than 30 years ago as Building Editor for both Sunset Books and Home Magazine. He has written more than 30 home improvement books and countless magazine articles. He appeared regularly on HGTV’s “The Fix,” and served as MSN’s home expert. Don founded HomeTips in 1996.

Related Posts:

Join the Conversation

1 Comment

  1. I have a Robert shaw thermostat on the wall and all the screen does is illuminat blue with no numbers or anything


Submit a Comment

Your email address will not be published. Required fields are marked *

Pin It on Pinterest